Ide to sata adapter settings
When I do not know: right-click on the "my computer - attribute", "hardware", "device manager", then open the "IDE ATA/PATA controller", and then double-click on the primary and secondary IDE channels, choose the "advanced Settings", "device type" is set to "automatic detection", "communication" is set to "DMA (if available) - point to confirm whether to restart the system to see the new hardware.Ħ. Due to poor product compatibility, the back is somehow Shared below. Most motherboards require BIOS setup (SATA mode to IDE mode)Ĥ, if it is not possible to have compatibility problems, then such a small device conversion card will have compatibility problems.ĥ. Test to see if the jumper is on the main disk and the value is in the position of the main disk.ģ, BIOS setup correctly boot. The product cannot be used for troubleshooting:Ĭheck if there is any problem with SATA data line and see if it is loose. When using IDE adapter devices, the jumper must be plugged into the primary bit.ġ0, compatible with SATA 1, SATA 2 generation, SATA 3 generation
IDE TO SATA ADAPTER SETTINGS DRIVER
Compatible with various brands of desktop:ġ, turn SATA IDE hard disk recorder, and then use the motherboard SATA port.Ģ, 3.5 inch IDE hard disk connected to SATA motherboard, SATA port useģ, IDE driver transfer SATA, and then use the motherboard SATA portĤ, IDE SATA, and then turn to burner motherboard SATA port useĥ, desktop 3.5 "IDE hard disk adapter using SATA VCR(please format your computer hard disk).Ħ, through the hard disk adapter can call the shots from the CD (need to re-install the system, BIOS refresh, etc.).ħ, after the adaptor's CD can be bootable system.Ĩ, riser card maximum support 1000G hard disk capacity parallel port.